Used for saw-cut installations where a 3/16” groove is cut into the concrete or asphalt and the wire is stuffed and sealed (using loop sealant) into the surface. Custom polyethylene outer jacket protects a micro-dusted nylon coated inner jacketed 16 AWG stranded wire. The saw-cut loop has a built in backer rod securely fitting a 3/16” saw cut groove eliminating the need to apply backer-rod to hold the loop to the bottom of the saw cut groove and requires 30-40% less loop sealant to seal. The entire loop including the lead-in fits within a 3/16” saw cut groove preventing wasted time spent double saw-cutting or doubling blades to cut the home run lead-in.
Use the TB-Kit to ensure the groove is cut exactly every time.
Loop should only be installed black side up to ensure phasing direction matches.
Align loop over saw-cut groove before insertion into the groove will prevent having to pull up and realign a tight fitting loop.
CALL NOW TO ORDER: (520) 303-4444
Custom Sizes with up to 1000’ lead-ins are available.
Custom orders ship same day if placed prior to 12 PM Pacific Standard Time.
Data from an in-depth report about the installation of pre formed inductive detector loops, written by: Turner-Fairbank Highway Research Center. The full, extensive report can be found here: Link
All content is copyright protected by GR8 Holdings LLC.
Disclaimer: All sales are final. Contact the webmaster at: GR8MFG@Hushmail.com
